Printable View
hmmm but i think it may be posible to get evrything out of the case and then place on a table and connect all the wires and touch screen and evrythig me and my friend did it with my old gba and ds... but it took ages... bout 6 hours for the ds and 3 for the gba... but the gba didnt work and the ds had lots of lag...
Well, I know I said I will buy a new one "soon" on January 23, but I'm actually getting one tomorrow.
I think.
That happened to a friend of mine. Her DS snapped in half at the exact same spot, I can even see a small crack appearing on mine too.
If your ribbon cable hasn't snapped yet you can buy a replacement shell and put all the guts into it.
My friend ordered a Shock-Shell (I don't recommend this brand, very flimsy and low quality) and I did the replacement for her (came with a "tri-wing" screwdriver for those nintendo screws).
Check out this guide and figure out if you're up to the challenge: http://www.flickr.com/photos/6264776...7594277451148/.
Some online stores sell OEM cases (presumably stolen from warehouses) that are 1:1 quality of the original case.
It took me about an hour to do it all.
Thanks a lot, but unfortunately the ribbon snapped on mine >_<
I like the "probably stolen" casing lol......
It is entirely possible to buy a new top screen: http://www.modchipstore.com/NDS-DS-LITE ... 16366.html
I bet if you searched around you could find one for less.
Although... with all the cost of parts (shell + screen) you're looking at a substantial chunk of the original price, so it might be best just to suck it up and buy a new DS...
Good luck though. If you do end up trying to repair it I might remember some pointers for the actual disassembly that would come in handy.